The two 10GE ports are fully independent on the module. Monitoring and control signals are mapped to the FMC interface for
detection, loss-of-signal, rate and device control. Atypically, the NIC onboard the FMC-10GE is enumerated and controlled as a
PCIe device, under the control of the ePC-K7’s quad-core i7 processor rather than the systems Kintex 7 FPGA, allowing use of
standard Windows/Linux applications to effectively leverage the communications ports. The FMC-10GE works with legacy
Gigabit Ethernet (GbE) switches and Cat 6e cabling.
The combination of FMC-10GE and Innovative ePC-K7 provides a powerful, stand-alone, FPGA-based wireless transceiver
Features
• Two independent 10GBASE-T interfaces with SR-IOV support
• 10 GbE/1 GbE/100 Mb/s copper PHYs integrated on-chip
• PCIe 2.1 (2.5GT/s or 5GT/s), Bus width — x1, x2, x4, x8
• Support for jumbo frames of up to 15.5 KB
• Flow control support: send/receive pause
frames and receive FIFO thresholds
• TCP segmentation offload: up to 256 KB
• IPv6 support for IP/TCP and IP/UDP receive checksum offload
• Fragmented UDP checksum offload for packet reassembly
• Message Signaled Interrupts (MSI)
• Message Signaled Interrupts (MSI-X)
• 128 transmit queues
• Receive packet split header
• Receive header replication
• Dynamic interrupt moderation
• Interrupt throttling control to limit maximum interrupt rate and improve CPU usage
• DCA support
• TCP timer interrupts
• No snoop
• Relaxed ordering
